2011 Honda Ruckus Custom

| 0
September 7, 2011 – This only received one bid for $2,800 and didn’t sell.

September 4, 2011 – Ruckusi are cool.  This overly modified moped is a waste of time and money in my view.  But then if I was 15 I’d be drooling over it.  Ok… I’m slightly wet mouthed now. Just goes to show you can get more power out of anything.

Only two decent pictures of four this guy offered but I’ve copied his post below.

On eBay FOR THE LAST TIME for $3,800 Buy it Now is Sioux Falls, SD.

“Up for sale is my 2011 Honda Ruckus 50cc scooter. I purchased this scooter new off the showroom floor at our local powersports dealer and have put a lot of time and money into it in order to make a unique and overall enjoyable riding experience. All parts were purchased brand new and I have never had a single issue with the scooter mechanically in any way. I would estimate that I have put an easy 3,000$ + worth of parts into it and with a sticker price of 2,499$ the total spent is well over 5k at this point. The only reason I am selling is I bought a truck for the winter and am going to build another Ruckus once I am done with school so until then id rather have this scooter find a good home instead of sitting in my garage. The scooter itself can go over 50mph on flat and I have clocked at around 55mph+ as my faster speed and that is with the 12×7 wheel so if swapped out to a skinnier rear wheel it might go even faster. Other than that it handles most grades of hills fine and with the current rollers I have in it the midrange pulls harder than off the line so its great for cruising in traffic where you need to speed up quickly. This is a quick list of the parts and modifications ive done and I may have forgot some as I built it early this spring.

Current Mileage: 415 miles
VIN: JH2AF5800BK701141

PWJDM bar kit
ncy lowered seat bracket
ncy gas tank cover
ncy peg kit
12×7 fatty rear
radiator PWJDM cover
Underseat LED tailight
LED front turn signals
Speedo relocated to battery box
KN lowering spring ~120cm-130cm height
Motor extension from ATR
PWJDM Billet black fuel cap
PWJDM ghost smoked swingarm cover
Custom kickstand (not the best but scoot is so low only option)
Custom bilttet bar end mirrors (only have one on the left side but still have the extra in box ~100$ retail for the pair)

Poloni variator kit 6.6g rollers
Kevlar belt
dr. pulley clutch kit
1500 clutch spring
cdi black box
20cm sheng way carb
foam air filter and k&n filters for breathers
PWJDM billet collant tank
NGK iridium IX plug
custom chopped yoshi exhaust
extended brake lines/fuel lines/ throttle cable

I may have some oem parts laying around in my garage, also I do have the oem carb still which can be put back on if buyer wants along with the oem rear wheel and oem rear shock. Depending on what is taken off I will deduct graciously from the final bid price to accommodate the changes or even throw in oem parts for dirt cheap to whoever buys the scooter.”

Leave a Reply

Your email address will not be published. Required fields are marked *