2010 Reproduction Enzo Ferrari Project Car

posted in: Online Around the Net | 1







“I HAVE FOR SALE A 2010 REPRODUCTION ENZO FERRARI. THIS CAR HAS A TUBE CHASSIS, COIL OVERS IN FRONT AND REAR, ALL HAND FORMED SHEET METAL BREAKS IN THE FRONT AND REAR. IT HAS A PONTIAC V6 ENGINE IN THE REAR WITH AN AUTOMATIC TRANSMISSION. HAS THE FUEL CELL INSTALLED BUT NEEDS TO BE CLEANED. THIS CAR IS EQUIPPED WITH GULLWING DOORS, HAS WIRING HARNESS AND AIR CONDITIONER THAT WORKS. THE BODY HAS SOME SURFACE RUST, BUT JUST NEEDS TO BE CLEANED. IT WAS SET UP FOR PLEXAN WINDOWS. THERE IS NO INTERIOR AND THE DASH NEEDS FABRICATION. THIS CAR HAS OVER “3000” HOURS OF FABRICATION IN IT AND AS FAR AS I KNOW IT IS THE ONLY METAL CAR IN THE U.S.A. THE ONLY REASON I AM SELLING IS I AM LOSING MUCH NEEDED STORAGE IN MY GARAGE.”

There are one maybe two things I could point out about this exercise but will ask one simple question:

Where does one get the dimensions/plans for an Enzo Ferrari?  I would think that would be an important item to note since I’m pretty sure he didn’t tape measure one in the parking lot. 

FYI – 3000 hours works out to be 375 days straight, no days off, 8 hour per day.
  

On eBay in Rogersville, Tennessee for $9,000 or Make Offer.

Leave a Reply

Your email address will not be published. Required fields are marked *